Advanced Engineering & Molding Technology-Injection Molding-Mold Making

https://www.plasticstoday.com//thinking-ou/86274044459519

That's a lot of shut-offs! The part is over 20" long. Do we have the skill to get it to fill? Check back later to see...#injectionmolding

If you're planning on attending the show next week in Anaheim, CA stop by a say hello.

Stop by and see us at the Pacific Design & Manufacturing Show 2012 in Anaheim, California February 14-16.

Tips and Tricks-When designing bosses, extend the core pin beyond the length of the screw to the bottom of the boss to reduce excessive material which will cause internal voids and sink marks on the exterior surface of your part.