Hall's Engine & Radiator

Decades old sign restored! New hand built security mailbox finished. Just a few COVID19 updates.

Poor design by General Motors. The pedal assembly is a plastic superstructure that all of the pedals, sensors, clutch master cylinder attach to. The complaint with this vehicle was the clutch failed. After a close inspection we found the clutch master cylinder was no longer held in place and simply moved with the clutch pedal. Turns out to be a pretty major job to remove the assembly and install the new one from Chevrolet.

Nice to see a good example of a 53 Chevrolet panel with a 216 and three on the tree.

Customer complaint of a slight vibration in their Mercedes. One more hard start from the light and this flex disc would have done some real damage!

Life is too short to not have an enjoyable ride! Not too many of these around.

1974 Corvette, mom drove the sons car to put tires on. And grenades the engine on the way. Windowed the block in two places. Usually the table is turned and the kid driving the parents car!

2016 Nissan Altima, surprisingly this car was still able to drive. Broken connecting rod broke through both sides of the block. Of course it had a check engine light for misfire and dash warning low oil pressure.

Not an unusual find in the oil pan of a 5.4l F150. The truck still ran but certainly not well. Ford is doing well selling all the timing components, updated oil pump etc... Nice truck and worth repairing but when the engine gets a bit noisy it's time to address the problem.

I fail to understand why a shop would use a sparkplug wire set not properly sized for the application. If a properly fitted part isnt available you should not install it. Custom fitted plug wires take more time but it is worth it.